Lanier GX3000 Manual do Utilizador descarregar pdf (Página 127)

124

Maintaining

Moving

The precautions when moving the printer a short distance or long distance are explained.

Moving a Short Distance

The precautions when moving the printer a short distance or long distance are explained.

1. Turn the power off, disconnect the USB cable, and then unplug the power cord from the wall out-

let.

2. Lift the printer using the indents on the printer's sides near the base, and then slowly lift and move

the printer without tilting.

Moving a Long Distance

1. Turn the power off, disconnect the USB cable, and then unplug the power cord from the wall out-

let. Do not remove the print cartridges. Remove the paper.

2. Pack the printer for transport when moving it a long distance such as when changing office or

residence. Disconnect all cables, place the printer in the box it was in when purchased, and trans-

port in a level manner. After moving the printer, first remove and then reattach the network inter-

face board.

The Machine weighs approximately 14.5 kg (32.0 lb.).

When moving the machine, hold the machine by the bottom below the two indentations. Lift the machine

slowly in order to avoid straining your body. Lifting the machine without sufficient strength or assistance

or handling it roughly and dropping it could cause an injury.

Unplug the power cord from the wall outlet before you move the machine. While moving the machine,

you should take care that the power cord will not be damaged under the machine.

When you disconnect the power plug from the wall outlet, always pull the plug (not the cable).

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 256 257

Sem comentários

Lanier GX3000 Manual do Utilizador Página 127